Preparation; Engine Oil - Energizer EZG2200iUK User Manual

(9). ECO Switch: Turning on this switch can slow the engine speed
when the load is reduced to save fuel, lessen noise and engine wear.
(10). Reset Button: This switch can be used to recover output of the
generator under the condition of overload protection, and unnecessary
to restart engine overall.
(11). READY LED (green): READY LED light comes ON when the
generator is operating normally. It indicates that the generator is
producing electrical power at the receptacles.
(12). OVERLOAD LED (red): If the generator is overloaded, or if there
is a short circuit at AC receptacles, the overload LED light (red) will go
ON, and current to the connected appliance(s) will shut off in a few
seconds.
(13). LOW OIL LEVEL LED (yellow): Lights up when oil level is below
safe operating level and the engine shuts down automatically. Unless
you refill with oil, the engine will not start again.
(14). POWER LED (optional): Lights up when the Gen-mate unit
(optional equipment) inside the generator is operating normally.
(15). Wi-Fi LED (optional): The light comes ON and flash slowly when
the generator with Gen-mate unit (optional equipment) is connected to
the Gen-mate APP in Smartphone by Wi-Fi.

4. PREPARATION

4.1 ENGINE OIL

NOTE
The engine has been shipped from our factory without oil. Put
⚫
oil before starting.
⚫ Recommended engine oil: 4-stroke engine oil, SAE 10W-40, API
SE/SF/SG/SH/SJ or higher.
⚫ Engine oil quantity: 0.4L.
- 27 -