Front Side Drive Bays - Supermicro AS -5014A-TT User Manual

A+ Workstation AS -5014A-TT User's Manual

Front Side Drive Bays

Two 2.5" drive bays are included along the front right side of the chassis. These drives are
not hot-swap, power must be removed from the system before removing or installing drives.
Installing/Removing the Front Side Drive Bays
Begin by powering down the system.
1. Push the release tab on either of the two drive bays so that the drive tray pops out from
the chassis.
2. Pull the drive tray out and install drives as needed. See the next section.
3. Push the drive tray and drive back into the bay and attach the wiring.
4. To remove drives from these bays, disconnect their wiring before pulling the tray from
the chassis.
Figure 3-9. Installing Front Side Drives
38
1
2