Installing Components In The 5.25" Drive Bays; Removing The Empty Drive Bay; Adding A Dvd-Rom Drive (Optional) - Supermicro SuperWorkstation SYS-530T-I User Manual

Installing Components in the 5.25" Drive Bays

The SYS-530T-I has two 5.25" drive bays. Components such as an extra DVD-ROM drive
can be installed into these 5.25" drive bays.

Removing the Empty Drive Bay

1. First power down the system.
2. Remove the top front cover of the chassis cover to access the drive.

Adding a DVD-ROM Drive (optional)

1. Remove the guide plates (one on each side) from the empty drive carrier and screw
them into both sides of the DVD-ROM drive using the holes provided.
2. Slide the DVD-ROM into the bay and secure it to the chassis with the drive carrier
screws you first removed.
3. Attach the power and data cables to the drive.
4. Replace the top front cover of the chassis and restore power to the system.
Chapter 3: Maintenance and Component Installation
34