Supermicro AS -5014A-TT User Manual page 69

•
(Example) linuxefi /images........quiet inst.dd modprobe.blacklist=ahci modprobe.
blacklist=nvme
Note: If the shell does not appear (the screen is black), reset and try with the settings below.
6. Add "inst.dd modprobe.blacklist=ahci modprobe.blacklist=nvme nomodeset" to the
end of the string, and press <Ctrl> <X>.
•
(Example) linuxefi /images........quiet inst.dd modprobe.blacklist=ahci modprobe.
blacklist=nvme nomodeset
7. In the Driver Disk Device Selection, insert the USB drive (which contains the AMD-RAID
dd-rcraid....x86_64.iso) into the USB port.
•
Press the <r> key, and press <Enter> to refresh.
•
Press the number key <2>, the number of the USB flash drive inserted above, and press
<Enter>.
8. In the Choose Driver Disk ISO file, press the number key <1> (the number of the dd-
rcraid-RHEL....el8.x86_64.iso entry), and press <Enter>.
9. In the Select Drivers to Install, press the number key <1> (the number of the /media/
DD/.....x86_64.rpm entry), and press <Enter>.
10. The /media/DD/... is now selected and should look like [X] /media/DD/......x86_64.rpm.
Press the <C> key and press <Enter>.
11. In the Driver Disk Device Selection, press the <C> key, press <Enter> key, and remove
the USB flash drive.
12. In the Welcome to Red Hat Enterprise Linux Screen, select the desired Language, select
the desired Country, and click Continue in the bottom right corner.
13. At the Installation Summary Screen, configure the following:
•
Under Localization, select these items to review the settings and make any necessary
changes:
•
Keyboard
•
Language Support
•
Time and Date
•
Under Software, select Software Selection.
•
Under Base Environments, select Server with GUI, and click Done in the upper left corner.
69
Chapter 5: Software