Power Supply - Supermicro AS -5014A-TT User Manual

A+ Workstation AS -5014A-TT User's Manual

Power Supply

The AS -5014A-TT chassis supports a power supply on the rear floor of the chassis. It is
recommended that the power requirements of installed components in the system total no
more than 80% of the power supply rating.
The 2000W power supply that comes standard with the AS -5014A-TT is a modular type power
supply that allows you to connect only the wiring you need for your system's configuration.
Attach all required wiring to the power supply then to your system as needed.
Installing Power Supply Cables
1. Power down the system as described in Section 3.1 and open the left side chassis
cover.
2. The power supply is isolated from the rest of the system with a cover. Remove the two
screws at the top of this cover as shown below.
3. Push in the release tabs along the bottom of the power supply cover to detach it.
4. Lift the cover up and out of the chassis.
2
Figure 3-24. Removing the Power Supply Cover
3
4
50