Set Alarm Server - HIKVISION DS-2DP8A440IXG-LEF/624(F0) User Manual

Note
Complete certificate management before selecting server certificate. Refer to Certificate
Management for detailed information.
SDK Service & Enhanced SDK Service
Check Enable SDK Service to add the device to the client software with SDK protocol.
Check Enable Enhanced SDK Service to add the device to the client software with SDK over
TLS protocol.
When you use Enhanced SDK Service, select the Server Certificate.
Note
Complete certificate management before selecting server certificate. Refer to Certificate
●
Management for detailed information.
When set up connection between the device and the client software, it is recommended to
●
use Enhanced SDK Service and set the communication in Arming Mode to encrypt the data
transmission. See the user manual of the client software for the arming mode settings.
TLS (Transport Layer Security)
The device offers TLS1.1, TLS1.2 and TLS1.3. Enable one or more protocol versions according
to your need.
Bonjour
Uncheck to disable the protocol.
3. Click Save.

10.10 Set Alarm Server

The device can send alarms to destination IP address or host name through HTTP, HTTPS, or ISUP
protocol. The destination IP address or host name should support HTTP, HTTP, or ISUP data
transmission.
Steps
1. Go to Configuration → Network → Advanced Settings → Alarm Server .
2. Enter Destination IP or Host Name, URL, and Port.
3. Select Protocol.
Note
HTTP, HTTPS, and ISUP are selectable. It is recommended to use HTTPS, as it encrypts the data
transmission during communication.
4. Click Test to check if the IP or host is available.
5. Click Save.
Stitched PanoVu Camera with PTZ User Manual
83