Kongsberg EA 600 Instruction Manual page 95

Note
857-164688 / E
→
Cable details, page 120.
C1226 - New line annotation (trigger input)
This input is referenced to digital ground. The cable must be
provided by the shipyard.
→
Cable details, page 120.
C1227 - Event annotation (trigger input)
This input is referenced to digital ground. The cable must be
provided by the shipyard.
→
Cable details, page 120.
C1228 - Remote on/off control
This input is referenced to digital ground. The cable must be
provided by the shipyard.
→
Cable details, page 120.
If an Hydrographic Operator Station is used, the on/off function
is supported on a dedicated connector.
If a standard computer is used, you must assemble a small
switch box to hold the necessary on/off switch.
C1229 - Synchronisation of GPT1
This cable is used to connect the GPT to an external system for
synchronization purposes. The cable must be provided by the
shipyard.
→
Cable details, page 120.
C1230 - Motion sensor (input)
This cable is used to connect the GPT to an external motion
sensor. The cable must be provided by the shipyard.
→
Cable details, page 120.
C1231 - Temperature sensor (input)
This cable is used to connect the GPT to an external temperature
sensor. The cable must be provided by the shipyard.
→
Cable details, page 120.
C1433 / C1533 - Transducer(s)
The transducer cable is fixed to the transducer. If the distance
between the transducer and the transceiver exceeds the length of
the transducer cable, a 1:1 junction box must be used.
The transducer cable between the transducer element and the
junction box or GPT must be run in steel conduits. Use flexible
conduit close to the GPT cabinet and the plug on the
transceiver.
Cable layout
85