Kongsberg EA 600 Instruction Manual page 165

Single beam hydrographic echo sounder
Table of Contents

Advertisement

Note
857-164688 / E
The cable's outer insulation will extend into the cable gland to a
point approximately 5 mm outside the outer surface of the
cabinet wall into which the cable gland is secured.
5
Take care not to damage the screening, carefully remove
the outer insulation from the required cable length.
6
Leave 12 mm of the screen exposed from the insulation,
cut off the remainder.
7
Take care not to damage the screening, slide the
compression nut (smallest diameter first) over the cable
and onto the intact insulation.
8
Taking care not to damage the screening, slide the
compression seal (rounded end first) over the cable and
onto the intact insulation.
9
Slide the screen collar (narrow end first) onto the cable
and fit it underneath the screen. Slide it as close to the
intact outer insulation as possible.
10
If the screen extends beyond the "flat" end of the screen
collar, fold any excess length over the end of the collar
such that the screen will be gripped between the collar and
the gland body when the parts are assembled.
11
Carefully thread the cable through the gland body till the
screen collar is tight into the gland body.
12
Slide the compression seal into the gland body till the
shoulder is hard up against the gland body.
13
Slide the compression nut over the compression seal and
engage the threads.
14
While holding the gland body to prevent it turning, and
pressing the cable into the gland, tighten the compression
nut onto the gland body.
15
Referring to the wiring diagram and ensuring that there is
5 to 10 cm. slack cable inside the cabinet, prepare and
connect the cable cores to the appropriate terminals within
the cabinet.
16
Secure the cable within the cabinet using cable clips.
17
Check the terminal connections against the wiring diagram
to ensure they are correct.
Follow the same procedure for all the cables and cable glands.
Once all the cables have been fitted:
18
Check the cabinet to ensure all tools and rubbish are
removed, then close the cabinet door.
Appendices
155

Advertisement

Table of Contents
loading

Table of Contents