Kongsberg EA 600 Instruction Manual page 150

EA 600 / Base version
Note
Caution
140
General unpacking procedure
Normal precautions for the handling, transportation and storage
of fragile electronic equipment must be undertaken.
If the unit is not to be prepared for immediate use, you may
consider storing it unopened in its original packing material.
However, it may be useful to open the case to check its contents
for damage and retrieve any accompanying documentation.
• Check the carton before opening it to ensure it shows no
signs of dropping, immersion in water or other mishandling.
- If the carton shows signs of such damage, refer to the
paragraph covering Inspection on receipt.
• Place the carton on a stable work bench or on the floor with
the top of the carton uppermost.
• In the absence of other instructions, always open the top of
the carton first. The contents will normally have been
lowered into the carton from above, so this will usually be
the easiest route to follow.
- Care must be used when opening the carton to ensure the
contents are not damaged.
Do not use a knife to open cardboard cartons - the
contents may lie close to the surface, and may be
damaged by the blade.
• If the carton has been closed using staples, remove the staples
from the carton as you open it. This will reduce the
possibilities of scratch injury to yourself and damage to the
contents.
• If a wooden crate has been closed using screws, always
remove them using a screw-driver. Do not attempt to prise
the lid off with a crow-bar or similar.
• Once the carton is open, carefully remove all loose packing
and insulation material. Check for manuals and other
documents that may have been added to the carton during
packing, and put these to one side. Check also for special
tools, door keys etc.
857-164688 / E