Cross Fold; Cross Fold Of Standard Paper - Formax FD 3302 Operator's Manual

Chapter 3 Advanced Operation
s.

Cross Fold

Cross fold is folding single-folded paper another time as shown in the figure.
The maximum paper thickness is fine quality paper 104.7 g/m
lbs. Rough paper, which is thin and flimsy, is not suitable for cross fold.
• Paper I dent and folding misalignment in both directions may
increase or paper may be fed unstably depending on the following
conditions. However, it is not a malfunction.
-The folded line of single-folded paper is not folded properly.
-Usage environment (temperature and humidity)
-Paper thickness, paper size, paper type, or paper grain direction, etc.
• Neither the optical sensor nor the ultrasonic sensor cannot be used for cross fold. Set both of
them to off.
&8 Do not put fingers inside during operation.
&
&
5-1.

Cross fold of standard paper

The following describes the cross fold of
standard paper, taking cross single folding
shown in the figure as an example.
7
Single fold standard paper according to the procedure of Chapter 2 "3.Standard Folding
of Standard Paper" (p.38).
2
Press the folded line of single-folded
paper with the fingertip.
The paper feeding state will be unstable or
r
paper dent may be caused if the folded line
of folded paper is not folded firmly.
58
&CAUTION
Keep away long hair, ties, jewelry and loose clothing.
It could cause injury.
2
/71.20 lbs and coated paper 157 g/m
....
2
/106.76