Table of Contents
Advertisement
TC-32B
12.3.12
-
When the M251 command is given, tap time stay constant when tapping of Z-axis speed .
-
When the M251 command is given, tap acceleration stay constant when tapping of Z-axis
speed.
12.3.13
This function is available for QT mounted machine.
-
When command M410 is executed, the Z-axis is returned to its origin and then the C-axis is
indexed to -180° (pallet 2 is positioned outside).
-
When command M411 is executed, the Z-axis is returned to its origin and then the C-axis is
indexed to 0° (pallet 1 is positioned outside).
-
When command M430 is executed, the C-axis unclamped by override.
-
When command M431 is executed, the C-axis clamped by override.
12.3.14
This function is available for QT mounted machine.
-
When M430 is commanded, the C axis is unclamped. Unclamping and clamping C axis is
not automatically controlled afterward.
-
When M431 is commanded, the C axis is clamped. Unclamping and clamping C axis is
automatically controlled afterward.
This command is valid when C is set to operate using the mashine paramater and the clamp
merchanism is set to [1:Type2]or[2:Type3].
An alarm will occur in other cases.
12.3.15
-
When M440 is commanded, the B axis is unclamped. Unclamping and clamping B axis
is not automatically controlled afterward.
-
When M441 is commanded, the B axis is clamped. Unclamping and clamping B axis is
automatically controlled afterward.
This command is valid when B is set to operate using the mashine paramater and the
clamp merchanism is set to [1:Type2]or[2:Type3].
An alarm will occur in other cases.
12.3.16
-
When M442 is commanded, the A axis is unclamped. Unclamping and clamping A axis is
not automatically controlled afterward.
-
When M443 is commanded, the A axis is clamped. Unclamping and
axis is automatically controlled afterward.
This command is valid when A is set to operate using the mashine paramater and the
clamp merchanism is set to [1:Type2]or[2:Type3].
An alarm will occur in other cases.
12.3.17
-
M450 and M451 commands proceed to the next block after output time has passed and the
signal has turned off.
-
M455 and M456 commands proceed to the next block without waiting until the signal turns
off.
-
The signal output time is set by user parameter 1.
2004/01/22
Tap time constant selection (M241 to 250)
Pallet related M codes
(M410, M411, M430, and M431)
Unclamping and clamping C axis
(M430 and M431)
Unclamping and clamping B axis
(M440 and M441)
Unclamping and clamping A axis
(M442 and M443)
One-shot output
(M450, M451, M455, and M456)
12 - 13
Chapter12 S,T,M function
clamping A
eTCOMNCPR12.doc
12
Advertisement
Table of Contents
