Brother TC-32B Manual page 219

TC-32B
Special uses of M99
If the M99 command is executed in the main program, the control returns to the start of
main program.
When optional
block skip is off;
If the programming is done as shown above, and if the optional block skip is OFF, the control
returns to the start of the main program and executes the program repeatedly up to N0100.
If the optional block skip is turned ON, the N0100 block is omitted and control goes to the next
block.
10.2 Simple Call
A subprogram can be called out from the main program or another subprogram and executed
accordingly.
Command format
If L is omitted, it is regarded as once.
(Note)
2004/01/16
/N0100 M99;
N0200
M98 P_L_ ;
P :
L :
If another G or M code is commanded in the M98 block, an alarm is
generated.
The axis movement is not available even by commanding X, Y or Z
address.
10 - 3
Chapter10 Subprogram function
When optional
block skip is on
M30;
Subprogram number to be called.
Number of execution to be repeated. (Max. 9999)
the
eNCPR11.02.ai
eTCOMNCPR10-1.doc
10