Brother TC-32B Manual page 107

TC-32B
(7) Block without movement
When the command without any X/Y movement is given for more than 3 blocks during the tool
dia offset mode, the movement is as shown below and overcutting or undercutting occurs.
N4 X_Y_;
N5 X0;
N6 X_;
N7 Z_;
N8 X;
(Note 1) The block with the movement amount zero will result in the same as above.
N4 G91 X_Y_;
N5 X0;
N6 X_;
(Note 2)
2004/01/22
Chapter4 Preparation function (Tool offset function)
Even if the X/Y movement command is not given at the start-up, the
start-up motion begins at the time the X or Y movement command is
executed.
4 - 25
4
eTCOMNCPR4.doc