Notes On Tool Dia Offset - Brother TC-32B Manual

TC-32B
4.1.10
(1) Command of tool dia offset amount
The offset amount is commanded by the number of the D command.
When G41 or G42 is commanded, the offset amount is commanded in the same block.
If it is omitted, the number of D command previously used becomes effective.
(2) Change of tool dia offset amount
When the offset amount is changed in the offset mode, the offset amount is changed at the end
point of the block.
N1 G41 X_Y_D1;
N6 Xa1 Yb1;
N7 Xa2 D2;....Change of offset amount
N8 Xa3 Yb3;
(3) Current position display
The current position display corresponds to the tool center position
(4) Machining of inner wall of circular arc smaller than the used tool radius
Alarmed stop
Since cutting is not available, the operation stops at the end point of the previous block and an
alarm is generated.
2004/01/22
Chapter4 Preparation function (Tool offset function)

Notes on tool dia offset

4 - 21
4
eTCOMNCPR4.doc