Table of Contents
Advertisement
Chapter 8 Automatic work measurement
(Note)
-
The setting values of MEASURING SPEED, RETURN DISTANCE AFT MEASURNG and so
on differ according to the probe mounted. Consult the probe maker and set the values.
-
During automatic work measurement, the speed that the probe moves to the
measurement start point or returns from the measured point conforms to the modal of
G00 and G01.
G00... Rapid traverse rate
G01... F command value
G02/G03/G102/G103/G202/G203...
-
Perform automatic work measurement with the tool offset function ON or the probe may
be damaged.
-
Check that the chips are not stuck to the measuring probe tip and the surface of the
workpiece to be measured. We shall not bear responsibility for the decreased
measurement accuracy due to the above cause.
-
The mode cannot be changed during automatic work measurement.
If mode selection is attempted, DURING AUTOMATIC WORK MEASURMENT alarm will
occur.
-
To prevent the probe from being damaged, press the [SINGL] key for the first automatic
work measurement and check the condition every single operation.
-
Tool length offset set first for automatic work measurement.
8
2004/01/30
IN ARC MODE alarm will occur
8 - 8
TC-32B
eTCOMNCPR8-1.doc
Advertisement
Table of Contents
