Chapter 5 Preparation function (canned cycle)
5.4.11
Command format
5
•
•
•
•
•
2004/01/22
Back boring cycle (G87)
Single block stop
Spindle orientation
specified by V
Z point
Dwelling for P sec
R point
If the minus value is commanded for the shift amount Q, the algebraic mark (-) is ignored.
The shift direction is selected from +X, -X, +Y and -Y set by the parameter 1 in advance.
The shift direction can be selected only from the above four. Therefore, the tool should be
mounted so that the tool nose faces in one of the specified direction when the spindle
orientation executes.
G99 (R point level return) is unused.
When V is omitted, 0° is considered to be commanded.
G87
X _ Y _ Z _ R _ Q _ P _ F _ S_ V_ ;
Q
Single block stop
5 - 20
TC-32B
Rapid feed
Cutting feed
Shift (rapid feed)
Spindle CW
Spindle CCW
eNCPR5.18.ai
eTCOMNCPR5-1.doc