S Function; T Function; Commanded By Tool No; Commanding By Pot No.(Magazine No.) - Brother TC-32B Manual

Chapter12 S,T,M function
12 S,T,M Function
By commanding the following functions, machine motions other than the axis
movements are available.
S
T
M
12.1

S Function

The S code is used for specifying the spindle speed.
The spindle speed is specified by the address S and a following within 5-digit number.
(Note 1)
The S command is not cancelled by the NC reset function, but it becomes zero
when the power is turned ON.
(Note 2)
The S command should be always given before commanding the spindle rotation
(M03,M04)
(Note 3)
When the S command is in the same block as that of axis movement, the S
command
12.2

T Function

When commanded, the magazine rotates to the corresponding pot.
Three commanded forms are provided as below.
12.2.1
Command format
Commanded by tool No. after "T" (T1-T99), and the pot with the corresponding tool attached is
Indexed.
12.2.2
Commanding by pot No.
Commanded the pot number (magazine number) using the two digit numerical values after "T1",
and the pot with the corresponding tool attached is indexed. (T101-T 1nn , "nn" indicates the
12
maximum numbers of the attached pots.)
12.2.3
Commanded the group number using the two digit numerical value after "T9"
( T901-T930), and the pot with the corresponding tool attached is indexed.
2004/01/22
: Spindle speed command
: Tool magazine number command
: ON/OFF command of various solenoids of the machine
becomes effective at the same time the axis movement starts.

Commanded by tool No.

T_ _ _;

Commanding by pot No.(magazine No.)

Commanded by group No.

12 - 2
TC-32B
eTCOMNCPR12.doc