M Function - Brother TC-32B Manual

TC-32B
12.3

M Function

The M codes are used for commanding ON/OFF of various solenoids of the machine.
It is commanded by address M and a following within 3-digit number.
When the M command is in the same block as that of the axis movement, the motion is devided
following three types.
The M command becomes effective before the axis movement starts.
The M command becomes effective at the same time the axis movement starts.
The M command becomes effective after the axis movement is finished.
(Note)
The modal command is effective until it is cancelled by the next M code or changed.
The one-shot command is effective only in the commanded block.
List of M code (1)
Group M code
M00
M01
M02
M30
M03
M04
M05*
M19
M111
M08
M09*
M06
M98
M99
The code with * is already set when the power is turned on.
2004/01/22
Content
Program stop
Optional stop
End of program
End of program
Spindle CW
Spindle CCW
Spindle stop
Spindle orientation
Spindle orientation (180°)
Coolant pump ON
Coolant pump OFF
Tool change
Sub program call
Return from subprogram
12 - 3
Chapter12 S,T,M function
Operation
Modal/
order v.
one-shot
axis feed
after one-shot
after one-shot
simultaneous modal
simultaneous
modal
after
simultaneous one-shot
eTCOMNCPR12.doc
12