Change Of Offset Direction In Offset Mode - Brother TC-32B Manual

Chapter4 Preparation function (Tool offset function)
4.1.7
By commanding G41 or G42, or converting the algebraic sign (+, -) of the offset amount, the
offset direction can be changed even in the offset mode.
The block not to be changed the next of start block.
As same as miller (Single axis commanding) and the case of changing the offset directon when D
adress position changed.
G code
Conditions of execution
Offset mode
4
When the offset direction is changed, the "inside" and "outside" cuttings are not
discriminated. But whether there is a cross point or not discriminates those cuttings.
The offset amount described hereafter has a positive value.
2004/01/22

Change of offset direction in offset mode

Offset amount sign
G41
G42
command
G41 G41
G42 G42
G41 G42
G42 G41
+
Left side offset
Right side offset
Linear-Linear Linear-Arc
Where the offset equivalent to the tool
dia is vertically applied to the end point
Perform
of the previous block
Perform
4 - 16
TC-32B
-
Right side offset
Left side offset
Arc-Linear Arc-Arc
Perform
eTCOMNCPR4.doc