Brother TC-32B Manual page 189

TC-32B
Item
MEASURING TRAVEL LMT
DISTANCE
MEASUREMENT TOLERANCE 1
MEASUREMENT TOLERANCE 2
MEASURNG
RETURN DISTANCE AFT
2004/01/30
Chapter 8 Automatic work measurement
Sets the amount of overtravel when the measuring skip has exceeded
the estimated value(program command value).
Setting range: 0.000~99.999 mm
0.0000~9.9999 inch
When the difference between the measured value and the estimated
value (program command value) has exceeded the preset value,
MEASD VAL ERR LRG(1) will occur. When 0 is set,the value error
check is not carried out.
Setting range:0.000~99.999 mm
0.0000~9.9999 inch
If the difference between the current measurement result and the
previous measurement result exceeds the setting range, MEASD
VAL ERR LRG(2) occurs. However, the difference is not
checked in the following cases:
*Zero (0) is set.
*1st automatic work measurement is performed after the power is
turned on (1st measurement for each of measurement results 1 to 4).
*No previous measurement result exists.
*Current G code differs from the previous G code.
Setting range: 0.000~99.999 mm
0.0000~9.9999 inch
Sets the amount that the measuring probe retracts where it has
contacted the non measuring object during automatic measurement.
*RETURN DISTANCE AFT MEASURNG = Lb (mm)
*SKIP FEED TIME CONSTANT 1 = t (msec)
*MEASURING SPEED 2 = F2 (mm/min)
Lb ≥ MAX (1.0，F2×t/6000)
Setting range: 0.000~99.999 mm
0.0000~9.9999 inch
8 - 7
Description
eTCOMNCPR8-1.doc
8