Clutch Cover - Club Car Carryall 295 2013 Maintenance And Service Manual

16
Clutches
NOTE: Ensure the hose is fully seated and the clamp is properly located and tightened.
7. Connect battery. See Connecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-4.
8. Drive the vehicle and check for proper operation.

CLUTCH COVER

Clutch Outer Cover Removal
1. Disconnect battery. See Disconnecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-3.
2. Remove the top air filter hose from the filter canister.
3. Remove the self-threading screws and remove the clutch outer cover.
Clutch Outer Cover Installation
1. Align the mounting holes in the clutch outer cover with the mounting holes in the clutch inner cover.
2. Install the screws and tighten the hardware to 72 in-lb (8 N·m).
3. Install the top air filter hose on the filter canister.
4. Connect battery. See Connecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-4. See
following NOTE.
NOTE: Ensure the hose clamp is tightly installed and positioned between the filter canister and canister port bead.
Clutch Inner Cover Removal
1. Disconnect battery. See Disconnecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-3.
2. Remove the outer clutch cover. See Clutch Outer Cover Removal on page 16-32.
3. Remove the drive belt. See Drive Belt Removal on page 16-25.
4. Remove the driven clutch. See Driven Clutch Removal on page 16-29.
5. Remove the bolts, nuts, and washers from the inner clutch cover (Figure 16-31, Page 16-33). See following
NOTE.
NOTE: When bolts are removed, note any bolt length differences around the flywheel. Some bolt holes have limited
depth and require a specific length of bolt thread.
Ensure the studs remain on the engine block when the nuts are removed.
6. Remove the clutch inner cover.
7. Remove the inner cover spacer between the inner cover and the engine block (Figure 16-32, Page 16-33).
Page 16-32 2013 Carryall 295/XRT 1550 Maintenance and Service Manual
All manuals and user guides at all-guides.com
DIESEL ENGINE, MUFFLER, FUEL SYSTEM,
AND CLUTCHES