Light Switch; Testing The Light Switch; Light Switch Removal; Light Switch Installation - Club Car Carryall 295 2013 Maintenance And Service Manual

14

Light Switch

LIGHT SWITCH
See General Warnings, Section 1, Page 1-2.

TESTING THE LIGHT SWITCH

See Test Procedure 34 – Light Switch on page 12-39.

LIGHT SWITCH REMOVAL

1. Disconnect battery. See Disconnecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-3.
2. Raise the hood.
3. Press the upper and lower retaining tabs and push the light switch (11) out of the instrument panel (Figure
14-6, Page 14-6).
4. Disconnect the wire harness from the light switch.

LIGHT SWITCH INSTALLATION

1. Match the terminal numbers molded onto the connector and switch and reconnect the wire harness.
2. Push the light switch into the instrument panel until fully seated.
3. Lower and secure the hood.
4. Connect battery. See Connecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-4.

FUSE

See General Warnings, Section 1, Page 1-2.

TESTING THE FUSE

See Test Procedure 2 – Fuse on page 12-13.

FUSE REMOVAL

1. Disconnect battery. See Disconnecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-3.
2. Remove the electrical component cover (located near the battery).
3. Remove the fuse from the fuse block.
Page 14-10 2013 Carryall 295/XRT 1550 Maintenance and Service Manual
All manuals and user guides at all-guides.com
ELECTRICAL COMPONENTS: DIESEL VEHICLES