Relay Removal; Relay Installation; Neutral Switch; Testing The Neutral Switch - Club Car Carryall 295 2013 Maintenance And Service Manual

14

Neutral Switch

RELAY REMOVAL

1. Disable the vehicle. See Disabling the Vehicle on page 1-3.
2. Remove the electrical component cover.
3. Remove the relay from the multi-pin connector.

RELAY INSTALLATION

Insert the relay into the multi-pin connector. See following NOTE.
NOTE: The relay contacts are keyed to ensure that the relay can only be installed in the correct orientation. If the
relay is not easy to insert, rotate the relay until the correct contact orientation is obtained.
NEUTRAL SWITCH
See General Warnings, Section 1, Page 1-2.
The neutral switch (1) is located on the transmission housing (Figure 14-2, Page 14-1).

TESTING THE NEUTRAL SWITCH

See Test Procedure 17 – Neutral Switch (Transmission) on page 12-28.

NEUTRAL SWITCH REMOVAL

1. Disable the vehicle. See Disabling the Vehicle on page 1-3.
2. Disconnect the two-pin connector between the neutral switch and the wire harness.
3. Use a wrench to loosen and remove the neutral switch from the transmission housing.

NEUTRAL SWITCH INSTALLATION

1. Install the neutral switch to the transmission housing. Tighten to 20.5 ft-lb (27.8 N·m).
2. Connect the two-pin connector between the neutral switch and the wire harness.
3. Connect battery. See Connecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-4.
Page 14-2 2013 Carryall 295/XRT 1550 Maintenance and Service Manual
All manuals and user guides at all-guides.com
ELECTRICAL COMPONENTS: DIESEL VEHICLES