Table of Contents
Advertisement
BODY AND TRIM
2.
The center cowl panel is held in place by four exposed Tuflok plastic locking fasteners and four metal body trim
clips that are hidden from view on the top, underside of the panel. Carefully remove the four Tuflok plastic
locking screws by using a size P2 Phillips head screwdriver. The outer portion of the Tuflok fastener may be left
in the panel at this time.
3.
Grab inside front corner of outboard end of the center cowl panel and firmly pull up to disengage one of the
outboard body trim clips. Repeat for other side.
4.
Lift up firmly on the front edge of the center cowl panel to disengage the two center body trim clips.
5.
Rotate front edge upward and lift off the entire center cowl panel to disengage the Tuflok fasteners and the rear
tabs of the panel out of the slots in the instrument panel structural support.
CENTER COWL PANEL INSTALLATION
1.
Position the center cowl panel to the vehicle, making sure that the rear tabs of the panel engage the slots in the
instrument panel structural support. Make sure that the tabs on the ends of the center cowl panel engage the
slots in the tops of the side cowl panels.
2.
Position and secure the center cowl panel to the instrument panel structural support by pressing down firmly and
directly over the four metal body trim clips on the underside of the panel.
3.
Install four Tuflok plastic locking fasteners along the trailing edge of the center cowl panel to secure the panel to
the instrument panel structural support.
4.
Replace, lower and secure hood. See Hood Installation on page 4-4.
SIDE COWL PANEL (FENDER) REMOVAL
1.
Remove Roll-over Protective Structure (ROPS), if equipped. See ROPS Removal on page 4-7.
2.
Remove hood. See Hood Removal on page 4-4.
3.
Remove center cowl panel. See Center Cowl Panel Removal on page 4-4.
4.
Disengage the three tabs securing the top of the side cowl panel from the three slots in the under-hood, inner
structure of the fender flare.
5.
Reach under the side of the fender flare and use thumb pressure on the three lower side-retaining tabs while
pulling upward on the front outboard edge of the side cowl panel to disengage the three lower side-retaining
tabs from the fender flare.
6.
Lift up on the front of the side cowl panel enough to disengage the rear side tab from the slot in the front side
of the instrument panel.
7.
Twist the front outside edge of the side cowl panel up, out and away from the centerline of the vehicle. This will
disengage the fender from the ROPS cowl support (if equipped) and the fender-retaining notch in the instrument
panel structural support.
8.
Remove side cowl panel from vehicle.
SIDE COWL PANEL (FENDER) INSTALLATION
1.
Position the side cowl panel to the vehicle.
2.
Insert the top rear, inside corner down and into the space between the ROPS cowl support (if equipped) and the
fender-retaining notch in the instrument panel structural support. Ensure that the top rear, inside corner of the
side cowl panel is engaged in the fender-retaining notch in the instrument panel structural support and that the
ROPS cowl support (if equipped) passes through the clearance hole in the side cowl panel.
3.
Rotate the side cowl panel down and over the ROPS cowl support (if equipped) until it is down and in place.
All manuals and user guides at all-guides.com
2013 Carryall 295/XRT 1550 Maintenance and Service Manual
Front Body Components
Page 4-5
4
Advertisement
Table of Contents
Troubleshooting
