Section 17 - Drivetrain Components; Half Shafts; Half Shaft Removal - Club Car Carryall 295 2013 Maintenance And Service Manual

SECTION 17 – DRIVETRAIN COMPONENTS
DANGER
• See General Warnings, Section 1, Page 1-2.
WARNING
• See General Warnings, Section 1, Page 1-2.
This section contains information on removing and installing the front differential, transmission, and rear differential.
Refer to the appropriate manual for complete instructions on disassembly, repair, rebuilding, and reassembly. See
the Engines and Drivetrain Components manual (CC P/N 102396501).

HALF SHAFTS

HALF SHAFT REMOVAL

1. Disconnect battery and spark plug wire(s) (gasoline vehicles only). See Disconnecting the Battery –
Gasoline/Diesel Vehicles, Section 1, Page 1-3.
2. Loosen the lug nuts on both front wheels.
3. Remove the rubber spindle nut covers from both front wheels.
4. Loosen the axle spindle nuts (Figure 17-1, Page 17-1).
5. Lift and support the front of vehicle and remove the wheel(s). See Lifting The Vehicle on page 3-8.
1895
Figure 17-1 Axle Spindle Nut And Washer
6. Remove both spindle nuts and large washers (Figure 17-1, Page 17-1).
7. Remove the upper shock absorber bolt and locknut.
8. Remove the lower shock absorber bolts and flanged locknuts. Remove the shock absorber and coil-over spring.
All manuals and user guides at all-guides.com
2013 Carryall 295/XRT 1550 Maintenance and Service Manual
17
Page 17-1