Table of Contents
Advertisement
Please use a setting that matches the specifications of your TV. After a selection is made, you
will be asked to confirm. Selection above 576i is only applicable on HDMI output.
Aspect Mode:
Use this option to select the aspect ratio of your TV and the preferred conversion method. The
options are: Auto (automatic detection of aspect ratio), 4:3 Panscan (Displays 16:9 widescreen
broadcasts full screen on your 4:3 TV), 4:3 letterbox (black bars on top and under the picture on
a 4:3 TV) and 16:9 (use this setting for 16:9 TV sets).
Connection:
Use this option to select the connection to your TV set. Select HDMI or TV SCART. If connection
type HDMI is selected, then only the CVBS signal is available on the TV SCART.
Digital Audio Output:
Toggles between PCM and Bitstream output. When PCM is selected, all digital audio will be
converted to stereo audio. Bitstream enables you to listen or transfer Dolby® Digital/Dolby®
Digital Plus* audio to the TV via HDMI or to a Home entertainment system (for example)
through coaxial S/PDIF.
NOTE:
Dolby® Digital Plus* is only available on the HDMI output.
* Dolby and the double-D symbol are registered trademarks of Dolby Laboratories
7.3.3 Local Time Setting
Here you can set up your region and time zone.
Region:
Use t u to select the region you live in.
GMT Usage:
Set to By Region for broadcaster defined time, User Define to select manual a GMT zone or to Off
to input time and date manually.
GMT Offset:
Allows you to adjust your time zone. This option is only available when GMT Usage is set to User
Define.The GMT Offset range is "-11:30 ~ +12:00", increasing by half hours progressively. The
cities matching the set GMT Offset are displayed at the bottom of the screen.
Daylight Saving:
Select On to add one hour for summer time.
Date:
Date and Time settings are available only when GMT Usage is set to Off. Use the 0~9 buttons to
enter the date. Press EXIT to proceed.
Date and Time settings are available only when GMT Usage is set to Off. Use the 0~9 buttons to
Time:
enter the time. Press EXIT to proceed.
Time Display
Select On to display time on screen, Off to remove.
7.3.4 Timer Setting
This menu allows you to set up to 8 timed events for recording or waking up the receiver.
Use pq to select Timer Setting from the System Setup menu and press OK to enter.
The receiver will display a list with 8 timers, followed by their respective status. Select the timer you wish to set or
change with pq and press OK to proceed.
The timer setup menu will now be displayed.
The following settings are available:
Timer Mode:
Choose between Off the timer is inactive, Once, Daily (the timer will be executed every day,
same time) or Weekly (the timer will be executed every week, same day, same time) and
Monthly (the timer will be executed every month, same day, same time).
Timer Service:
Choose between Channel (the timer will wake up the receiver) or Record (Timer will start
recording the scheduled event).
Wakeup Channel:
Use t u to select the channel the timer will wake up with.
Wakeup Date:
Use the 0~9 buttons to enter the date for the timed event.
Wakeup Time:
Use the 0~9 buttons to enter the starting time.
Duration:
Use the 0~9 buttons to enter the duration of the timer.
When all settings have been made, use pq to move the highlight to Save and press OK to confirm. To quit the timer
without saving your settings, move the highlight to Cancel.
13
Advertisement
Table of Contents
