Table of Contents
Advertisement
User manual
P/N 3-9008-513
4. Lightly tap the center bolt from the downstream rotor end with a soft-faced mallet
5. Install the nut, washer and flow conditioning plate.
9.4.3
Assemble internal meter housing components - NPS 3
through 4
Stainless steel bearing internals assembly
Procedure
1. Remove the bearing assembly retaining rings to inspect and/or replace the
2. Install the bearing assembly into the diffuser.
to tighten the compression on the support fins.
Figure 9-30: Nut, washer and flow conditioning plate installation
individual ball bearing units if necessary.
Figure 9-31: Bearing assembly retaining rings removal
USER MANUAL
Planned maintenance
September 2020
71
www.Daniel.com
Advertisement
Table of Contents
