DANIEL 1200 Series User Manual page 63

User manual
P/N 3-9008-513
9.3.3 Disassemble internal meter housing components - NPS
3 through 4
The internal components of the Series 1200 Turbine Meter are held in place by self-
centering support fins, pressed against the flow conditioning plate.
Procedure
1. Remove the nut, washer, and flow conditioning plate from the center bolt.
2. Lightly tap the center bolt on the end with a soft-faced hammer (mallet) to loosen
3. Gently remove the internals from the flow tube.
User manual
Figure 9-10: Nut, washer, and flow conditioning plate removal
the compression on the support fins.
Push the shaft flush with the support fins and lift the fins slightly to remove them
from the groove inside the flow tube.
Planned maintenance
USER MANUAL
September 2020
63
www.Daniel.com
73