Table of Contents
Advertisement
User manual
P/N 3-9008-513
2. Lightly tap the center bolt on the end with a soft-faced mallet to loosen the
3. Gently remove the internals from the flow tube.
4. Remove the nut from the downstream (rotor) end of the internal bullet after laying
Figure 9-5: Nut, washer and flow conditioning plate removal
compression on the support fins. Align the shaft flush with the support fins and lift
the fins slightly to remove them from the groove inside the flow tube.
Figure 9-6: Internals removal
the support fins aside.
USER MANUAL
Planned maintenance
September 2020
61
www.Daniel.com
Advertisement
Table of Contents
