Table of Contents
Advertisement
User manual
P/N 3-9008-513
3. Install the C-clip at the inlet flange using pliers.
9.4.2
Assemble internal meter housing components - NPS 1.5
through 2
Procedure
1. Fully assemble the internals. The rotor assembly includes the rotor, two stainless
User manual
Figure 9-25: Sleeve installation
Figure 9-26: C-clip installation
steel ball bearing assemblies and a spacer between the ball races. The ball races are
a loose fit in recesses on the rotor hub and may fall out. Be careful not to lose any
small parts. Install the downstream stator and rotor into the bolt.
Planned maintenance
USER MANUAL
September 2020
69
www.Daniel.com
79
Advertisement
Table of Contents
