Table of Contents
Advertisement
8.5.23 BACK ADJ.
Max.
Min. value
value
+9.9
-9.9
Note:
1. The reverse feed amount fine adjustment value is the sum of the fine adjustment values set in the system
mode (by key operation) and set by command (from the PC). The max. value is ±9.9mm.
Note:
There may be cases where a label is not returned to the home position depending on the print
conditions, even if the media is fed backward for the same amount as the forward feed. For issuing
media with the media sensor, if the label pitch is almost the same as the distance between the print
head and the media sensor (69.8 mm), the media may not be returned to the home position when
operations including a reverse feed (such as cut issues, strip issues, automatic forward feed) are
performed. It may result in an error. To prevent this error from occurring, increase the reverse feed
amount by performing the reverse feed amount fine adjustment in the + direction.
Step
Display
0.1
Decimal
+0.0mm
+3.0mm
-3.0mm
Integer
Decimal
Sign
digit
Exist
1
Print start position
(Home position after a back feed)
Print start position
(Home position after a back feed)
Print start position
(Home position after a back feed)
85
Unit of
0-padding
place
measure
1
None
mm
Advertisement
Table of Contents
