Removing The Generator; Removing The Starter Clutch; Checking The Starter Clutch - Yamaha XVS950CU 2014 Service Manual

EAS24490

REMOVING THE GENERATOR

1. Remove:
• Generator rotor bolt "1"
• Washer
TIP
• While holding the generator rotor "2" with the
sheave holder "3", loosen the generator rotor
bolt.
• Do not allow the sheave holder to touch the
projection on the generator rotor.
Sheave holder
90890-01701
Primary clutch holder
YS-01880-A
2. Remove:
• Generator rotor "1"
(with the flywheel puller "2")
• Woodruff key
ECA1TP1029
NOTICE
To protect the end of the crankshaft, place an
appropriate sized socket between the fly-
wheel puller set's center bolt and the crank-
shaft.
TIP
• Install the flywheel puller bolts to the threaded
holes of the starter clutch.
• Make sure the flywheel puller is centered over
the generator rotor.
Flywheel puller
90890-01362
Heavy duty puller
YU-33270-B
GENERATOR AND STARTER CLUTCH
2
3
EAS24560

REMOVING THE STARTER CLUTCH

1. Remove:
• Starter clutch bolts "1"
• Starter clutch
TIP
While holding the generator rotor "2" with the
sheave holder "3", loosen the starter clutch
bolts.
Sheave holder
90890-01701
Primary clutch holder
YS-01880-A
2
1
EAS24570

CHECKING THE STARTER CLUTCH

1. Check:
• Starter clutch rollers
Damage/wear → Replace.
2. Check:
• Starter clutch idle gears
• Starter clutch gear
Burrs/chips/roughness/wear → Replace the
defective part(s).
3. Check:
• Starter clutch gear's contacting surfaces
Damage/pitting/wear → Replace the starter
clutch gear.
4. Check:
• Starter clutch operation
5-45
1
3