Yamaha XVS950CU 2014 Service Manual page 125

1. Lean angle sensor
2. Tail sub-wire harness
3. Wire harness
4. Clutch cable
5. Starter motor lead
6. Rear brake light switch
7. O sensor
2
8. Rear wheel sensor coupler
9. Rear wheel sensor lead
10. Brake fluid reservoir hose
11. Positive battery lead
12. ABS test coupler
13. Frame
14. Rear brake light switch lead
A. Insert the projection on the tail sub-wire harness
holder into the hole in the battery box.
B. Secure the holder by inserting the projection on
the holder into the hole in the battery box bracket,
and then fasten the clutch cable and wire harness
with the holder.
C. Insert the projection on the starter motor lead
holder into the hole in the engine bracket (front
lower side).
D. Insert the projection on the starter motor lead
holder into the hole in the engine bracket (rear
lower side).
E. After connecting the rear wheel sensor coupler,
cover the coupler with the coupler cover.
F. Fasten the rear wheel sensor lead, brake fluid
reservoir hose, rear brake light switch lead, and O
sensor lead with the plastic band. Make sure to
route the rear wheel sensor lead to the outside of
the frame.
G. Fasten the brake fluid reservoir hose, rear brake
light switch lead, and O
plastic band. Face the buckle of the plastic band
upward with the end pointing downward.
H. Insert the projection on the wire harness holder
into the hole in the battery box.
I. Insert the projection on the positive battery lead
holder into the hole in the battery box.
J. Position the ABS test coupler to the rear of the
battery and under the lean angle sensor.
K. Face the catch of the holder forward. Route the
clutch cable to the outside of the wire harness.
L. Fasten the wire harness with a plastic locking tie
within the range shown in the illustration.
M. Route the rear brake light switch lead and starter
motor lead through the guide, and then secure the
leads by bending the guide around the leads.
Route the rear brake light switch lead to the
outside of the starter motor lead. Make sure that
the leads do not protrude.
N. Fasten the wire harness to the frame with a plastic
locking tie. Cut off the excess end of the plastic
locking tie.
O. Fasten the wire harness to the frame with a plastic
locking tie. Face the buckle of the plastic locking tie
inward, and then cut off the excess end of the tie.
sensor lead with the
2
CABLE ROUTING (for ABS models)
2
2-82