Yamaha XVS950CU 2014 Service Manual page 209

▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Insert the front wheel axle from the right side
and tighten it to 59 Nm (5.9 m·kgf, 43 ft·lbf).
b. In the order pinch bolt "1" → pinch bolt "2" →
pinch bolt "1", tighten each bolt to 20 Nm (2.0
m·kgf, 14 ft·lbf) without performing temporary
tightening.
2 1
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
5. Install: (for ABS models)
• Front wheel sensor
Front wheel sensor bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
ECA1XC1020
NOTICE
• Make sure there are no foreign materials in
the front wheel sensor rotor and front
wheel sensor. Foreign materials cause
damage to the front wheel sensor rotor and
front wheel sensor.
• To route the front wheel sensor lead, refer
to "CABLE ROUTING (for ABS models)" on
page 2-75.
TIP
When installing the front wheel sensor, check
the wheel sensor lead for twists.
6. Measure:
• Distance "a"
(between the front wheel sensor rotor "1" and
front wheel sensor "2")
Out of specification → Check the wheel bear-
ing for looseness, and the front wheel sensor
and sensor rotor installation conditions
(warpage caused by overtorque, wrong in-
stallation direction, rotor decentering, LOC-
TITE® on the mounting surface of the rotor,
deformation caused by an impact during ser-
vice and caught foreign materials). If there is
any defective part, repair or replace the de-
fective part.
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
▼▼▼
TIP
Measure the distance between the front wheel
sensor rotor and front wheel sensor in several
places in one rotation of the front wheel. Do not
turn the front wheel while the thickness gauge is
installed. This may damage the front wheel sen-
sor rotor and the front wheel sensor.
▲▲▲
a
1
7. Install:
• Front brake caliper
• Front wheel sensor lead holder (for ABS
models)
EWA1TP1001
WARNING
Make sure the brake hose is routed properly.
4-18
FRONT WHEEL
Distance "a" (between the front
wheel sensor rotor and front
wheel sensor)
0.5–1.3 mm (0.02–0.05 in)
Thickness gauge
90890-03180
Feeler gauge set
YU-26900-9
2
2
1
Front brake caliper bracket bolt
40 Nm (4.0 m·kgf, 29 ft·lbf)