Yamaha XVS950CU 2014 Service Manual page 348

6. Install:
• Clutch spring plate
• Clutch spring plate retainer
Clutch spring plate retainer bolt
8 Nm (0.8 m·kgf, 5.8 ft·lbf)
TIP
Tighten the clutch spring plate retainer bolts in
stages and in a crisscross pattern.
7. Install:
• Oil seals "1", "2"
(to the clutch cover)
Installed depth "a"
1.0–1.5 mm (0.04–0.06 in)
Installed depth "b"
0–0.5 mm (0–0.02 in)
a
1
8. Install:
• Clutch cover
• Clutch cable holder
2
b
• Starter motor lead and rear brake light switch
lead holder
Clutch cover bolt "1"–"13", "15"
12 Nm (1.2 m·kgf, 8.7 ft·lbf)
Clutch cover bolt (with washer)
"14"
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
TIP
Temporally tighten the bolts "a" and "b", and then
tighten the clutch cover bolts in the order shown
in the illustration.
9. Install:
• Pull lever spring "1"
• Pull lever "2"
• Washer
• Circlip New
TIP
• Make sure that the mark "a" on the pull lever is
facing forward.
• When installing the pull lever, push it and
check that its punch mark "b" aligns with the
mark "c" on the clutch cover.
• Make sure that the pull rod teeth and pull lever
shaft pinion gear are engaged.
10.Adjust:
• Clutch lever free play
Refer to "ADJUSTING THE CLUTCH LEVER
FREE PLAY" on page 3-10.
5-57
CLUTCH