Advertisement
Assembly
9
In this step, assembly is completed by attaching the torque tube and raising
and clamping the foils.
Norseman/Sta-Lok
Instructions
®
Norseman/Sta-Lok
installations are identical to swaged
®
wire at this point.
March 1999
Use 4 mm allen wrench to secure the torque tube to the
drum assembly using the three screws provided. Use
blue Loctite
on screws.
®
Tip: Insert all three screws BEFORE tightening.
Raise the foil so the top rides over the swage fitting at
the top of the headstay wire and is within 1
of the pin holding the stay to the masthead toggle.
Tip: Walk away from the boat and check the height
by looking at the top of the foils with binoculars.
Failure to raise the foils will result in considerable
friction while furling. Raising foils too high may
prevent the foils from rotating.
Insert the torque tube screws and use the 5 mm allen
wrench to securely clamp the foils in a raised position.
Rod Instructions
Rod installations are identical to swaged wire at this point.
Unit 0 MKIII
/
" (38 mm)
1
2
25
Advertisement
