Advertisement
Assembly
2
In this step, the first foil connector is inserted into the top foil and secured using wedges, adhe-
sive and screws.
Norseman/Sta-Lok
Instructions
®
Because the lower end of the wire is open you will not "free" a
connector, but will simply slip one onto the wire and to the top
of the headstay.
March 1999
Free one connector and slide it towards the top of the
stay. Completely remove the tape. Tape can jam or
damage the unit if left on the wire.
Coat the top half of the connector and the indentation
with red Loctite
. Place a plastic connector wedge in the
®
indentation.
Tip: Proper use of the adhesive is the most important element of
proper foil assembly.
USE PLENTY OF ADHESIVE. (RED LOCTITE
Push the connector into the foil until the screw hole in
the connector lines up with the hole in the foil.
Coat foil connector screw with red Loctite
into the connector until it is tight.
Rod Instructions
Rod installations are identical to swaged wire at this point.
Unit 0 MKIII
®
)
and screw it
®
17
Advertisement
