Advertisement
Assembly
6
In this step, the drum is attached and the unit is readied for installation on the boat.
Do NOT use the plastic locking cylinder.
Thread the locking collar onto the drum
assembly as far as it will go.
April 2004
Slip the locking collar onto the stay over the swage stud
with the threaded end of the collar down.
Slip the plastic locking cylinder onto the swage stud and
into the locking collar, split end first.
Thread the drum assembly onto the stay until the
colored mark on the threads does not show.
The coloring on the threads warns of insufficient
thread engagement. It is provided only for your con-
venience and may wear off. The only positive means
to insure proper thread engagement is to measure
the exposed threads. At no time should more than
1
/
1
top or the bottom of the turnbuckle.
Norseman/Sta-Lok
and Rod Instructions
®
Thread the drum assembly onto the stay
until the colored mark on the threads
does not show.
Unit 0 MKIII
" (38 mm) of thread be exposed at either the
2
21
Advertisement
