Table of Contents
Advertisement
Helix S5000 10° IP65
To operate the device with a DMX controller:
01) Select DMX or CRMX mode in the DMX menu. See 6.6.1.3. DMX Signal on page 33 for more
information.
Set the DMX starting address of the device in the DMX Address menu. See 6.6.1.1. DMX Address on
page 32 for more information.
03) Select the DMX channel mode in the DMX Configuration menu. See 6.6.1.2. Channels on page 33 for
more information. See 6.7. DMX Channels on pages 42–46 for complete overview of all DMX
channels.
6.3.
Control Panel
●
Use the MODE button to open the main menu or to exit the current submenu and return to the main
menu.
●
Use the UP/DOWN buttons to navigate through the menus or to increase/decrease numeric values.
●
Use the SET button to open the desired menu, to confirm your choice or to set the currently selected
value.
6.4.
Start-up
Upon start-up the display shows the start screen. The start screen provides information about the software
version, the temperature of the LEDs, the DMX starting address of the device, and the selected DMX
channel mode:
Note:
If no button is pressed, after 30 seconds of inactivity the display will turn off. To unlock the display, you
have to press and hold down the MODE and SET buttons for 3 seconds. Once you have pressed the
buttons, the display will light up.
Product code: 43724
A) DMX LED indicator
B)
OLED display
C) UP button
D) SET button
E)
DOWN button
F)
MODE button
Fig. 19
29
Advertisement
Table of Contents
