Table of Contents
Advertisement
Helix S5000 10° IP65
Connect the Helix to the Wireless DMX Signal Transmitter
The Helix cannot actively match a random wireless signal transmitter.
To pair the Helix with the wireless signal transmitter, please check the manual of the wireless signal
transmitter you use. We advise you to use the BlackBox F-1 Tranceiver G6 (52001) by LumenRadio.
Disconnect the Helix from the Wireless DMX Signal Transmitter
01) Turn off/unlink the CRMX. In order to do so, deactivate CRMX (see 6.6.1.4. CRMX Unlock on page 33
for more information).
02) Unlink the Helix (see 6.6.1.4. CRMX Unlock on page 33 for more information).
03) The Helix will now be disconnected.
Setup Example 1
The Helix cannot send any wireless signals. Therefore, the slave Helix fixtures must always be connected
via a DMX signal cable.
Note:
The Helix S5000 10° IP65 is only a CRMX receiver and never a CRMX transmitter.
When the Helix operates in DMX or Slave mode, it can receive a wireless DMX signal (CH1–512) and at
the same time it can also send a DMX signal, via its 5-pin XLR-HD connector (03), through a DMX cable.
Product code: 43724
26
Fig. 17
Advertisement
Table of Contents
