Electrical installation of the power cabinet
5. Install the nuts and washers on the connector block bolts.
6. Tighten the nuts to the correct torque. For the specification, refer to section
12.14.
7.5
Connect the AC auxiliary power cable in the power cabinet
Preliminary requirements
Procedure
1. Strip the insulation from the ends of
the wires (A) to (D).
•
•
2. Crimp ferrules onto the end of the
wires. Refer to section 11.2.
3. Loosen the screws of the terminal
block X-10.
4. Connect these wires:
•
•
•
•
5. Tighten the screws to the correct torque. For the specification, refer to section
12.14.
46
•
Torque screwdriver, cross
•
Wire cutter
•
Wire stripper pliers
•
Crimp pliers
•
AC auxiliary power cable.
Refer to section 12.19.4.
•
Ferrules
Note: The AC auxiliary power cable provides the control power to the
charge post.
For the procedure, refer to section
11.2.
For the specification, refer to
section 12.19.6.
PE wire (A), green/yellow, to the
terminal X10-1 (E)
L1 wire (B), brown, to the terminal X10-2 (F)
L2 wire (C), black, to the terminal X10-3 (G)
L3 wire (D), grey, to the terminal X10-4 (H)
•
E
F
G
H
9AKK107992A2254-EN | 005
D
C
B
A