Power Up Modes; Bypass Mode For Mono I/O - Strymon ULTRAVIOLET vintage vibe User Manual

Power Up Modes

Bypass Mode for Mono I/O

With the rear I/O Mode Selector set to mono, the UltraViolet pedal
is set for True Bypass as the default�* Setting UltraViolet to Buffered
Bypass Mode preserves the high frequency response of your
instrument's signal through your pedal chain and long cable runs�
*NOTE: Whenever the rear I/O Mode Selector set to mono
stereo, the bypass mode is automatically set to Buffered Bypass�
1
Press and hold the footswitch for at least 2 seconds while powering
up UltraViolet� Once the LED flashes RED, release the footswitch�
2 Toggle the BIAS (BYPASS) switch to choose between True or Buffered
Bypass Modes� The LED will change color to indicate the current
status as you toggle the switch�
• True Bypass: set the switch to the low (left) position� The LED
GREEN
lights
• Buffered Bypass: set the switch to the high (right) position� The
LED lights RED�
3 Press the FOOTSWITCH to store the Bypass Mode and begin using
UltraViolet�
NOTE: The Bypass Mode setting persists across power cycles�
blend
chorus vibrato
MODE
INTENSITY
SPEED
vintage vibe
(default)�
BYPASS
mid
low high
BIAS
VOLUME
stereo or
pg 8