Table of Contents
Advertisement
Framing dimensions
The main points governing location are flueing and warm air distribution. The Rinnai Evolve has an
integrated zero clearance box that isolates the appliance from combustible materials. This means
it can be installed directly into a decorative fireplace constructed from materials such as wood or
plaster.
W
H
D
Left
wheel
Joist
For the Evolve 1253 there is an
additional wheel in the center
To ensure the appliance performs correctly, without rattling, it must be installed on a flat level
support base that allows free movement of the appliance. The joists used to support the appliance
off the ground must be capable of supporting a minimum of 1.5 times the weight of the appliance.
Wheels, located at the rear of the heater, allow the unit to slide in and out of the enclosure for
installation and maintenance.
If mounting at floor level remember to account for the outer frame dimensions. We have had
calls about the frame not fitting as the dimensions have not been factored when framing the
NOTE
enclosure.
850 mm (Evolve 952)
1030 mm (Evolve 1253)
Plywood board, min. 18 mm
Enclosure dimensions
952
W-width
965-980 mm
H-height 570-580 mm
D-depth
570 mm min.
Right
wheel
Joist
Evolve 952/1253 Installation Guide: 13115-F 06-22 | 9
1253
1265-1280 mm
570-580 mm
570 mm min.
Installer please note
Issues caused by 'rattling'
fires not installed on a flat
level base, as detailed in
these instructions, will not be
covered by warranty.
Advertisement
Table of Contents
