Framing Dimensions - Rinnai Evolve 952 Series Installation Manual

Framing dimensions

The main points governing location are flueing and warm air distribution. The
Rinnai Evolve has an integrated zero clearance box that isolates the appliance
from combustible materials. This means it can be installed directly into a decorative
fireplace constructed from materials such as wood or plaster.
W
H
D
Left
wheel
Joist
For the Evolve 1252 there is an
additional wheel in the center
To ensure the appliance performs correctly, without rattling, it must be installed on a flat level
support base that allows free movement of the appliance. The joists used to support the appliance
off the ground must be capable of supporting a minimum of 1.5 times the weight of the appliance.
Wheels, located at the rear of the heater, allow the unit to slide in and out of the enclosure for
installation and maintenance.
850 mm (Evolve 952)
1030 mm (Evolve 1252)
Plywood board, minimum 18 mm
Enclosure dimensions
952
W-width 965-980 mm
H-height
570-580 mm
D-depth 570 mm min.
Right
wheel
Joist
Evolve 952/1252 Installation Guide: 13115-E 05-19 | 9
1252
1265-1280 mm
570-580 mm
570 mm min.
Installer please note
Issues caused by 'rattling'
fires not installed on a flat
level base, as detailed in
these instructions, will not be
covered by warranty.