Table of Contents
Advertisement
Install burn media - stones
The glass retainer will need to be removed before installing the stone set and granules.
Use extreme care when handling the stones, they are made from a fragile material and will
damage easily.
Use these instructions in conjunction with the burn media guide sheet, which is
attached to the engine. Experience has shown that the majority of performance
problems have been caused by the burn media being installed incorrectly.
IMPORTANT
It is important to place the pieces in the correct position. Incorrect placement can create
carbon build-up and affect performance. Malfunctioning due to improper stone/granule
placement is not covered by warranty. The unit must never be used with broken stones or
other burn media (except those specifically designed for the Evolve).
Before commencing installation ensure you have the correct stone set. The Evolve
952 stone set contains 30 stones, the Evolve 1253 stone set contains 40 stones. The
installation between the two models varies slightly.
Evolve 952
Please note: Shadow effect on front section of the burner makes the front two rows of stones appear lighter—all
stones are a similar grey colour
L1
CO
CO
= front grey cut out stones (x5)
N.B: The flame rod and pilot position has changed, these photos depict an older model.
1. From the stone set identify the five front grey
cutout stones.
L2
L4
CO
CO
L3
L5
CO
L1-L6
= large grey stones
2. Place the five grey cutout stones on the burner
brackets at the front as shown below.
Evolve 952/1253 Installation Guide: 13115-F 06-22 | 21
L6
CO
Advertisement
Table of Contents
