Installation; Connection To The Mains Power Supply; Replacement Of The Power Cord; Terminal Box - ROSIERES RDCV 49 MIN Instructions For Installation And Use Manual

INSTALLATION

Remove the appliance from the package
and check that the product and power cord
are NOT damaged.
Otherwise, contact the retailer before
operating the appliance.
Do not lift the product by the door handle.
Packaging (e.g. paper, polystyrene) may be
hazardous to children (danger of suffocation).
Keep packaging out of the reach of children.
The product must be installed and connected
correctly to the mains power supply,
following the manufacturer's instructions and
only by QUALIFIED PERSONNEL .
Before performing any type of work, it must
be verified that the appliance is
DISCONNECTED from the mains power
supply.

Connection to the mains power supply

Make sure the voltage matches that
indicated on the typeplate which can be
viewed by opening the oven door.
Check whether there is an omnipolar
switch available on the domestic line
which is compliant with current standards
(3 mm minimum opening distance
between contacts) and if it is able to
support the load of the appliance (see the
typeplate). Otherwise place a device,
easily reach able, between the appliance
and the electricity line with the described
specifications.
CAUTION: Check whether your
electrical system is equipped with an
efficient earth connection according to
current standards and legal provisions.
N.B. The earth connection is required by
law.
The yellow/green earth cable must not be
interrupted by the switch and must be 2 -3
cm longer than the other cables.
Do not position the power cord near
sources of heat or at temperatures more
than 50° above the room temperature.
If the appliance is lacking the power cord,
the oven must be connected to the mains
power supply with a cable having a
minimum section of 1.5mm
If a plug is to be used, it must be a
standard plug suitable for the load and
the power outlet.

Replacement of the power cord:

If the power cord needs to be replaced, use
cables of the following type only:
H05 RR-F, H05V2V2-F(T-90)
Wire sections 3x1.5mm

Terminal box

The oven is equipped with a terminal box set
up for operation with a single -phase 220-240
Vac 50 Hz supply voltage.
Picture of the open terminal box showing the
connected wires.
2
.
2
7