Mounting To Linear Actuator - Siemens SIPART PS100 Operating Instructions Manual

NOTICE
Freezing of the exhaust air outlets
The exhaust air outlets
• Do not install the positioner with the base plate
①
②
Figure 4-1
4.2

Mounting to linear actuator

Requirements
Depending on the stroke height, you will need the following mounting kit:
• 3 to 35 mm mounting kit 6DR4004-8V
• 35 to 130 mm mounting kit 6DR4004-8V and additional 6DR4004-8L
Procedure
Sr. no. Quan‐ Name
*) tity
6DR4004-8L:
①
1 Lever
6DR4004-8V:
①
1 NAMUR mounting bracket
IEC 60534
②
1 Pick-up bracket
③
2 Clamping piece
④
1 Carrier pin
SIPART PS100
Operating Instructions, 06/2023, A5E50188938-AF
②
can ice up. The function of the device is impaired.
Base plate
Exhaust air outlets
Exhaust air outlets, base plate
Note
For the range of stroke from 10 to 130 mm
Standardized connection point for mount with fin, column or plane surface
Guides the pulley with the carrier pin and rotates the lever arm.
Installs the pick-up bracket on the actuator spindle
Installation with pulley
4.2 Mounting to linear actuator
①
pointing up.
⑤ ⑥
on lever
Installing/mounting
21