Dimm Installation; Dimm Removal - Supermicro B13SEG Owner's Manual

Super B13SEG User's Manual

DIMM Installation

1. For the system to work properly, use
memory modules of the same type and
speed. Refer to the table in
the memory population sequence.
2. Align the DIMM module key with the
receptive point on the single-latch DIMM
slot.
3. Push the release tab outwards to unlock
the slot.
4. Align the notch on the end of the module
against the receptive point on the end of
the slot.
5. Press both ends of the module straight
down into the slot until the module snaps
into place.
6. Push the release tab to the lock position to
secure the module into the slot.

DIMM Removal

Press the release tab on one end of the DIMM
module to unlock it. Once the DIMM module
is loosened, remove it from the memory slot.
Chapter 2.4 for
32
LEDM1
PRESS FIT PRESS FIT
MH4
MH2
MEZZ1
PWR2
25G LAN
JUSB1
CX-4
BMC
JRK1
JTPM1 PCH
CPLD
JBT1 JPME1
MH5 MH6
CPU
BT1
BAR CODE B13SEG
REV:1.00
MH7
JFP1
PCIE1A
MH9
LED2
MH8
JPWR_SLOT1 JPWR_SLOT2 JPWR_AOC2 JPWR_AOC1
MAC CODE
Receptive Point
Notch
Release Tab
Press both notches
straight down into
the memory slot.