Front Panel Header - Supermicro B13SEG Owner's Manual

2.5 Front Panel Header

JFP1 contains header pins for various buttons and indicators that are normally located on a
control panel at the front of the chassis. Connect an FPC cable from JFP1 to the front panel
module for power on/off, KVM, and other system LED notifications. Refer to the table below
for LEDs and their functions. This connector is designed specifically for use with Supermicro
chassis. See the figure below for the descriptions of the front control panel buttons and LED
indicators.
Function
Power Button
Power LED
KVM/UID LED
Network/IB LED
System Fault
LED
PRESS FIT PRESS FIT
MH2
PWR2
25G LAN
JUSB1
CX-4
JRK1
JTPM1 PCH
JBT1 JPME1
MH5
CPU
BT1
BAR CODE
MH7
JFP1
PCIE1A
LED2 MH8
JPWR_SLOT1 JPWR_SLOT2
State Description
N/A Turns the blade module on and off.
Green Indicates power status "On."
Solid Orange Indicates power status "Off" (with power cables plugged in).
Flashing Orange Indicates the node is not ready or not enough power to turn on.
Blue Indicates KVM is in use by the blade unit.
Flashing Blue Indicates UID is activated on the blade module.
Flashing Green Indicates network activity over LAN.
Flashing Orange Indicates network activity over the Infiniband module.
Indicates a memory error, overheat, VGA error, or any other
Red
error that prevents booting.
LEDM1
MH4
MEZZ1
BMC
CPLD
MH6
B13SEG
REV:1.00
MH9
JPWR_AOC2 JPWR_AOC1
MAC CODE
33
Chapter 2: Installation