Table of Contents
Advertisement
DIMM Installation
Caution: Exercise care when installing or removing DIMM modules to prevent damage.
Installing DIMM Memory Modules
1. Power down the blade module (see
page
2-1).
2. Remove the blade from the enclosure.
3. Remove the air shroud that covers the DIMM slots.
4. Insert each DIMM vertically into its slot, starting with slots A1 and A2. Pay attention
to the notch along the bottom of the module to prevent inserting the DIMM
incorrectly (see
Figure 2-4. Installing a DIMM into a Memory Slot
To Install: Insert module vertically
and press down until it snaps into
place. Pay attention to the bottom
notch.
To Remove: Use your thumbs to
gently push each release tab
outward to free the DIMM from the
slot.
Note: The notch should align with
the receptive key point on the
5. Gently press down on the DIMM until it snaps into place in the slot. Repeat for all
modules.
6. Replace the air shroud and install the blade module back into the enclosure.
7. Power up the blade unit (see
page
2-1).
Figure
2-4).
"Powering Up a MicroBlade Module Unit" on
Chapter 2: Setup and Installation
"Powering Down a MicroBlade Module Unit" on
Side View
Release Tabs
Top View
2-5
Notch
Advertisement
Table of Contents
